













Zcintert Reflective Safety Tape 2 Inch x 33 Feet, DOT-C2 Yellow Conspicuity Reflector Strip for Trailer Truck Vehicle
-
Kathryn Health
> 3 dayIt keeps falling off, whether its my van or bumper or trailer. Three different types of materials, does not stick and stay. Clean & dry surfaces to begin with.. maybe they just gave me an old roll?
-
Beaumont
> 3 dayYou dont really have much lighting when spending outdoors camping, unless you use electrical hook-ups constantly or have unlimited batteries or time to charge your lighting devices. Sometimes the solution is simple--make mundane stuff visible by adding a reflective tape on them. This one has good thick material and good quantity on it. It will last me for a while as I have this as just a just in case tool/material. For something like this, a specialty tape, it could have come with a protective casing or storage of some sort. But all the same, I like it for what it is and what it can do for me.
-
Tony
> 3 dayIt did not stick well on my bumper. Had to use glue to to make it stick better. Do not buy it.
-
Osmey Guillen Fernandez
> 3 dayTrailer
-
Miz J
> 3 dayNot much to say about reflective tape. I put some on my fender and used a flash. It definitely reflects and is very noticeable. The backing peels off easy and it sticks well. It is a single color but for me that is fine. Priced right for what you get.
-
Valtex
> 3 dayI was expecting a roll of 160 but got like half. not cool.
-
Robert Crandall
> 3 dayI like to have a reflective tape on the mail box and this works great for that. Sadly though my Step Daughter ran into the corner of my shop. She claimed she didnt see it. :) So I added a small strip to each corner of the shop as well.
-
mindoza-us
> 3 dayAfter two weeks The top layer (red)started to peal off leaving just a silver part
-
Richard Kelly Moore
> 3 dayDidnt stick to my trailer very well.
-
uniq
> 3 dayThe only problem I have found so far is with peeling of the reflective layer when separating the thin tape that protects the glue layer. First, its hard to prime the peeling, so I had to twist back and forth the edge of the tape piece to get the thin fil a bit separated, then pulled with small plyers. However, every time a piece of the reflective layer pealed as well for about 1/8-1/4.