100 Pack 608-2RS Skateboard Bearing, Rolling Bearings, 8x22x7mm 608rs Bearing

I was expecting to get the same bearings in the picture which showed ABEC-7 bearings. They also came very dirty and greasy. They barely rolled and was just a half step up from the 20 year old rusty ABEC-1 bearings that were on the board before hand. Changed the wheels and trucks so I know that wasnt the problem.

It’s 100 Skateboard Bearings COME ON! Buy them now!!!! Must clean first from factory residues and spray with a bearing solvent to get some actual use out of them.. I bought these to sell with my skate wheels and it worked! They can be skated! Risk It MANE!

Good bearings. Slight surface corrosion on outside but none visible under seals. Light coat of oil here and there but no evidence of intentional lubrication inside. Clean, lubricate, and inspect seals before use.

these are the worst bearings ive encountered on amazon as of yet, the price really was too good to be true. they arrived super sticky as if they used sugar water as a lubricant. they also require many pounds of force before they even roll. do your self a favor and do not buy

Nice product.

These are 608RS bearings a good value. At first they were listed as having a nylon bearing cage but, in fact, they are steel. I contacted the seller (a small startup) and they responded immediately and corrected the description. Unlike another reviewer here, I did not find the bearings that I received to be full of grease, though. There certainly was some grease inside. If using these for light loads, like skateboarding, try opening up one side and putting a couple of drops of light oil in (I used silicone oil) and give it a few turns to thin out the lubricant a little. That really makes these spin well. If using these for heavy loads and high RPM, leave the grease in, of course, without thinning. But, if using them for light loads, thinning the lubricant may just do the trick for you.

I used these bearings on two pairs of rollerblades. 32 bearings. 1/2 are breaking down and have spilled grease. 1 bearing completely blew out and shot bearings everywhere. Ive been rollerblading since 93. Its the bearings. Unsafe at any speed.

Don’t spin as freely as I would have hoped ended up buying another brand to be able to do what I was trying

I like em alot

these are better then bearings on a $20 skateboard from walmart