4 Pack Knotted Wire Wheel Brush for Angle Grinders, WENORA Wire Brush for 4 1/2 Angle Grinder with 5/8 Inch Threaded Arbor, with 5/8 Inch Arbor for Heavy Cleaning Rust, for Grinder

These are rust eating wheels if you can stand the flying wire. BE SURE TO WEAR EYE PROTECTION WITH THESE WHEELS. A full face shield is best.

Got this kit to remove loose paint and rust on a steel square tube Wrought Iron style fence, mounted this first wire wheel on our Milwaukee cordless grinder and have been diligently stripping paint layer after paint layer along with spots of rush and some slag on our welds from installation. These wire wheels are truly heavy duty and very reasonably priced. Ive ground for hours now and the first wheel is still going strong!

If youre looking to remove rust, paint or even clean up wood these are my go-to. These stainless Wheels last a long time and I will definitely be purchasing more of in the future!

These have been instrumental in removing decades of caked on grime and paint from the 74 Beetle we are restoring. One thing we learned in using them was that when they start to un-knot themselves, they are still useful for light weld cleanup and surface clean-up, however they are not as effective at that point at rust removal and the like. Weve purchased a second set of these as we wore through our first set.

Used these wheels to sand down and clean a stock trailer for pain prep. They definitely held up and there’s lots of life left in them. Absolutely with the money.

These have been instrumental in removing decades of caked on grime and paint from the 74 Beetle we are restoring. One thing we learned in using them was that when they start to un-knot themselves, they are still useful for light weld cleanup and surface clean-up, however they are not as effective at that point at rust removal and the like. Weve purchased a second set of these as we wore through our first set.

It should work well!

These wire wheels are pretty hard to mess up. After just a few seconds in my 4 1/2 in it took the rust off an old piece of tube steel I had laying around, the old grease/dirt/rust buildup off an old 3/4 ton shock, and the paint off a 55 gal drum lid. I say that, however to be honest Im surprised I dont have any wires sticking out of me after looking at the wheel after the fact. A number of wires seem to of come loose and could be removed with minimal issue or force. They get the job done but I question the longevity.

These wire wheels are pretty hard to mess up. After just a few seconds in my 4 1/2 in it took the rust off an old piece of tube steel I had laying around, the old grease/dirt/rust buildup off an old 3/4 ton shock, and the paint off a 55 gal drum lid. I say that, however to be honest Im surprised I dont have any wires sticking out of me after looking at the wheel after the fact. A number of wires seem to of come loose and could be removed with minimal issue or force. They get the job done but I question the longevity.

The way these are made allows you to use them horizontal or vertical and because they use a heavier wire than on the wire wheels I have used. Cup wheels flair out, these maintain shape and regular wire wheels dont like side loading, these dont seem to mind and work well doing it. So far I havent seen any shedding of wire from the bristles but that dont mean it wont happen. Wear your eye protection and gloves.