5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips

I kind of but the bottom area is a little too harsh so it can break or damage the bed

Works on my glass bed for my 3 ended 3 pros perfectly! Very low profile and slim so it doesn’t take up much of the print area, and hold the bed very well in where it needs to be without shifting for quality prints every time!

Works as advertised. Simple screw based clamps for bed surfaces for things like an Ender 3. If youre off into a space where the usual Ender mods arent, using Polypropylene or Garolite for a bed surface, this is one of your better choices here. It also works GOOD for Glass, etc. so you might want to contemplate this for your tempered/Borosilicate bed surface to help hold it down to the bed itself better. The only drawback is that you might have to position the clamps around the bed to compensate for physical accessibility to the screws relative to the bed adjuster knobs and the rest of your printers frame. Not a problem, per se, with the product- but this is being said so you go into this eyes-open and know theres things youll need to work out and think about using these before you go off printing with them.

ender 3 using pei sheet, not glass. i had to remove the springs on these to get it to work, but they work fine, better than binder clips

Greatly Exceeded my expectations!

Good replacement for the original clips

I originally received clips that did not match the product description. The seller reached out and sent the proper clips. Id have given 5 stars if the clips were correct the first time -giving 4 stars instead because it took a few weeks to get the replacements. Original review: The upper left part of the 5th image shows that these clamps have a foot on the end of the screw that presses against the bottom of the bed. Unfortunately, this foot is not included with the product.

For some reason I could not level the back left corner of my Ender 3 neo. Ended up snapping a screw so I order this and with the new springs I had no issues at all leveling the bed. Finally I’m able to start printing!

The only real issue I have with these is that I didnt need 12 and itd be cool if they could be purchased in packs of 4-6 for less money.

I use this on my Ender 3 v2 Neo with a Creality 4mm glass bed. Works perfectly and these clips hold well and stay out of the way.