5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips

Greatly Exceeded my expectations!

These are lightweight but well made. Now I can use my whole bed and feel much more stable than the stock binder clips. Highly recommend!

These do the job. I am currently using them to hold the glass bed I picked up for my Ender 3 S1 Plus, and they are holding it in place admirably. They list the spring as some kind of benefit, but there really is no point in the spring. For one, the spring is far far too light to really offer any level of assistance, further, with how the spring is positioned, it is doing nothing, so its really just a gimmick. That being said, as a screw, literally the oldest machine in the history of humanity, these do precisely what they are intended to do, and have yet to explode, so 5 stars!

I originally bought these to have something nicer looking and more low profile to hold my magnetized flexible build plate after I used it at too high temps for a little while and it lost magnetism. However these WILL NOT work for thin build plates unless you add something in between to buffer them, on their own they just dont reach. However they work great for the stock ender 3 glass bed and the replacement G10 sheet I got on amazon, I use them with the G10 often. The only other complaint that I have is that they leave a blue stain under the clamp top and it spills out. It doesnt change anything functionally but its still kinda strange and undesirable.

These dont clear the extruder fan on the left side nor the heater block in the back so I can only clip on the right side. But recommended, get something shorter

The only problem I have is that the black clamps sit a little high even when tighten down. I’ve noticed this with my printer so it might be different per person. But I noticed depending on the print the extruder will run into the clamp and jam it’s self. Again largely depends on what your printing.

These clips hold my bed on without issue. I am not able to swap out glass plated with ease and quickly change bed material print to print. Id recommend these if youre printing on a glass sheet that you dont want to adhere to the aluminum. Im personally using these on both an Anycubic Chiron and an Ender 3.

The wheels look nice on my ender but they definitely rub the bed. Going to have to add a washer or two to space it out. The clips are nice and hold down my 4 mm glass bed well. The springs seem to be a lot stronger than stock.

Havent used them yet but looks good