













5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips
-
Thew
> 3 dayThese arent a lot smaller than binder clips but the difference is quite noticeable: no more snags on fan duct similar to thing #2814127 = no more launched clips = no more bed slippage = fewer failed prints. Does take a bit longer to remove/replace glass bed & felt expensive to purchase up front, but Ive spent just a much on binder clips over the past few years and probably have already broken even on filament costs just from fewer failed prints. Ive put these on 2 of our 3 printers now. Only reason not all 3 is the magnetic bed in the third has never presented a single reason to consider anything else.
-
Dan
> 3 dayI originally received clips that did not match the product description. The seller reached out and sent the proper clips. Id have given 5 stars if the clips were correct the first time -giving 4 stars instead because it took a few weeks to get the replacements. Original review: The upper left part of the 5th image shows that these clamps have a foot on the end of the screw that presses against the bottom of the bed. Unfortunately, this foot is not included with the product.
-
TechReviews
> 3 dayThese are lightweight but well made. Now I can use my whole bed and feel much more stable than the stock binder clips. Highly recommend!
-
(◕દ◕)
> 3 dayThese dont clear the extruder fan on the left side nor the heater block in the back so I can only clip on the right side. But recommended, get something shorter
-
Jeff Bezos (official)
> 3 dayGreatly Exceeded my expectations!
-
Chuck Rider
> 3 dayWorks great. Low profile. Holds well.
-
Adam watson
> 3 dayGood replacement for the original clips
-
Doug Greer
Greater than one weekThe clips are exactly what one would expect, no surprises. Good hardware holding it down
-
John C
> 3 dayThe wheels look nice on my ender but they definitely rub the bed. Going to have to add a washer or two to space it out. The clips are nice and hold down my 4 mm glass bed well. The springs seem to be a lot stronger than stock.
-
Landon Swoboda
> 3 dayWorks on my glass bed for my 3 ended 3 pros perfectly! Very low profile and slim so it doesn’t take up much of the print area, and hold the bed very well in where it needs to be without shifting for quality prints every time!