5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips

I was absolutely sick of clips if they where not just right they would get hit by my cooling HeroMe Gen 5 On my cr10s pro the clips are screwed the the hotbed and swing over the plate taking up almost no room. I ordered these, tossed the silver ones away and used the screw based clamp. The screw for me is on the bottom of the hotbed. In doing it this way almost no clearance issues but you have to be careful not to screw it so much you damage the bed.

They work perfectly and look great, much better that paper clips.

They first sent me a high temperature copper heat block, seems nice, but not what I need. Once the replacement came all was good. These clips allow me to use my glass plate over a magnetic pad. They do not get in the way and do not take away any build volume over original clips for ender 3 v2.

These dont clear the extruder fan on the left side nor the heater block in the back so I can only clip on the right side. But recommended, get something shorter

Good replacement for the original clips

These small aluminum c-clamps (with thumb screw) SECURE the TOP GLASS on heated bed of Ender 3 v2 printer - in most efficient way. These clamps are SUPERIOR when compared to “spring clips”, that came with Ender 3 v2 printer.

Kinda springy, kinda clippy, kinda wheely... I like it!

They fit perfect and add more adjustability of bed surface

I originally bought these to have something nicer looking and more low profile to hold my magnetized flexible build plate after I used it at too high temps for a little while and it lost magnetism. However these WILL NOT work for thin build plates unless you add something in between to buffer them, on their own they just dont reach. However they work great for the stock ender 3 glass bed and the replacement G10 sheet I got on amazon, I use them with the G10 often. The only other complaint that I have is that they leave a blue stain under the clamp top and it spills out. It doesnt change anything functionally but its still kinda strange and undesirable.

I have an E3 with the creality glass bed. there are thinner stainless steel clips specifically for it but these add versatility because they are adjustable for different thicknesses of build plates and how tight I want to hold it down. they take up very little space on the bed and are almost as out of the way as the stainless steel ones that only work with a specific thickness of bed. they hold as well or better than regular binder clips and are about as quick to remove and install. bottom line, Im calling these a win and dont mind recommending them. just dont overtighten, they are aluminum and you can strip the threads without too much torque.