8 Pieces 3D Printer Heatbed Parts Silicone Leveling Solid Bed Mount 3D Printer Heatbed Part Stable Hotbed Heat-Resistant Buffer Compatible with CR-10 Ender 3 Bottom Connect (Black,0.63 Inch, 0.7 Inch)

fit and finish is very good

I replaced the stock leveling springs with these on my Ender 3. Combined with a bed Auto-Leveler like the CR-Touch they make a huge difference in keeping the bed level.

The thing with silicone solid bed mounts is they arent really very solid if they have relief sections on either end. I assume these are for using lock nuts on the upper section, with the nuts taking up the open section. This really isnt necessary for solid bed mounts and is really an answer to a question that doesnt need to be asked. Ultimately I think 3d printed solid mounts in ABS would be better but for the most basic application, these could work. You cannot tighten much with these, as they deform and you cant get a consistent height. You would have to put them in place with very minimal torque and likely either nylok nuts or at minimum thread locker.

I bought them for my Ender 3 V2 and they work great! The less often that I have to keep leveling my bed the better heheeh

Very inaccurate sizing, as each spacer has its own height. Measured each with my caliper and none were equal height. Luckily most print beds have adjustment screws to compensate for this poorly made product.

I installed these on my printer, Creality Ender 3 Pro, and the work perfectly!

im getting more reliable mesh in kipper

They do work but I ended up going back to the stock orange springs, these are really finicky to fine tune

Worked well on my CR-10S for replacing the bed springs. The shorter one goes on the back-left screw since it has the bed strain relief bracket.

After installing them Ive only has to level the bed once.