













ABN Hollow Punch Kit Leather Punches Tools Hole Punch Set Gasket Punch Set Gasket Cutter 3/16 to 1-3/8in (5-35mm)
-
dave h
> 3 dayWork good after I sharpened them with a drumel
-
Kindle Customer
> 3 dayeasy to use and love the centering spot.
-
Jim
Greater than one weekThe foam gaskets on my car which seal each tail light bulbs are not available anywhere. They have an inner dimension of 25 mm and an outer dimension of 35 mm. Was cheaper to buy this set than buying individual punches. With a little practice, was able to make very nice replacement gaskets.
-
The american
> 3 dayWell made and nice case should work well for my gasket making
-
Dr. Makenzie Batz
> 3 dayTried cutting small fleece circles. They never tell you what kind of surface to use. Started with wood, but just pressed into the wood and dented the fabric. Plastic on the wood finally did cut fabric after it cut through the plastic, but now have to buy as much plastic as fabric. Tried soft or thin metals, but same as wood and plastic. Tried a heavy duty cutting mat, thicker than quilter style mats, and again the fabric would not cut unless you hit really hard; then it cuts through the mat and uneven cuts on fabric. Tried metal similar to door hinge, not too hard, not too soft. Notta. After a few hits, the punch rolls inwards. Now a nice little biscuit cutter with non-threatening edges, other than the dough would catch up in the rolled up edge of the punch. Why cant someone make a punch that cuts fabric! You can cut metal and leather, but not fabric. I just dont get it!
-
K
> 3 dayUsed to punch holes in carpet for installation of posts of closet system. Worked really well for something it was not necessarily designed for.
-
Mifflee
> 3 dayPoor quality ,mala calidad ...mala mala ,no lo recomiendo
-
Paul G
> 3 dayI have already used these a good number of times and they look like they did new still. They cut clean round holes in gasket material. These are just what I had been looking for.
-
M_G_A
08-06-2025I bought this set for its variety of sizes; that was a plus. I needed to make ONE specific rubber gasket. The performance of the cutting edges was sub-par; in a 1/8 piece of rubber, I had to pound the cutter 10+ times, pretty hard, to get it to cut through. Not what I was expecting.
-
glenn d gibbs
> 3 dayJust what I needed. Waited too long to purchase.