Adhesive Neoprene Rubber Mat 1/8 Inch (.125”) Thick x 12 Inch Wide x 59 Inch Long, Closed Cell Foam Sheet Roll

Kind of speedy, but it works well.

I bought this to pad the liner of a hat to make it slightly smaller. It fit just right and works perfect. The Neoprene acts as a barrier and helps protect the hat fabric from becoming sweat stained.

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

Product was as expected,very satisfied.

I couldnt peel off the paper fully. It just comes off partial and I can not put it on where I want it to be put on. I had to put screws to hold it. The surface was so slippery after I put it on the board.

It was described as a rubber adhesive mat. It’s definitely not rubber. More like soft flat foam. I already cut it so I didn’t return it. But if you want a rubber mat as described, this isn’t it.

Use for spot on my foot that is swollen and painful. Excellent relief from pain and redness. Because of the high friction in that area I needed to augment the adhesive with some duct tape quack quack. One might also need two layers with a whole cut in the center.

I bought it to pad the hard plastic arms of a cheap office chair. The padding is not thick enough and the odor was intolerable.

Didnt know what this stuff was until I started watching audio install videos and everybody recommended this material. It works great to make sure the rattles and rolls are only coming from your Elvis tracks and not from the plastic components inside the dash after you install your aftermarket head unit.

The thickness 1/16 is just perfect fit. The material is flexible and easy to cut and reshape. I used it to protect the pipe of my AC and works as expected.