Adhesive Neoprene Rubber Mat 1/8 Inch (.125”) Thick x 12 Inch Wide x 59 Inch Long, Closed Cell Foam Sheet Roll

It is amazing how many little uses this has once you own it. I.e. I put a light/ laser on handgun and just could not get it tight enough. Made a small cushion and it is now perfect. Awesome

Used to make a replacement foam gasket on a floor cleaner. Worked well.

Great for light-duty low-pressure gaskets to seal out air and moisture.

Couldn’t remove the backing in order to install this. It tore so easy and /or left some paper over the glue. I included a temp photo to show I was inside the operating range listed for the product. Wasted my time and money here for sure.

Used for car radio installation. Very useful for protecting components and preventing rattle.

Use for spot on my foot that is swollen and painful. Excellent relief from pain and redness. Because of the high friction in that area I needed to augment the adhesive with some duct tape quack quack. One might also need two layers with a whole cut in the center.

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

I bought this piece to use it as isolation for speakers, it works fine, I didnt give it 5 stars due to the piece was not nicely cut, it was irregular.

Im getting so tired of being asked to rate the thickness of stuff on this app! It is the thickness that it specifies in the description! Used as a cheek pad on a rifle and it has stuck through adverse weather and recoil so it is for sure some good stuff!!

I bought it to pad the hard plastic arms of a cheap office chair. The padding is not thick enough and the odor was intolerable.