Adhesive Neoprene Rubber Mat 1/8 Inch (.125”) Thick x 12 Inch Wide x 59 Inch Long, Closed Cell Foam Sheet Roll

Product is less than 12” wide and it is cut very uneven/crooked. We shall see how it sticks and holds up. It should do the job for my project.

This worked perfectly for me. I had to replace the foam that surrounds the kick plate on my 77 project car. The kick plate has a vent and door on it to allow air in. The existing foam seal that goes around the vent door had dried up long ago. So when it rains, water flows down the cowl drains, it goes inside the fender well and leaks through the kick plat because of the dried up foam. I cut the new pieces out using a utility knife. Luckily 12 inches die was exactly the width I needed. I then applied it to the kick plate the sticky part adhered to the plastic just fine. I installed it, put in the screws then put a garden hose down the cowl. No water got inside. I can now move on to restoring the floor of the car, as I could not do it until the leaks were fixed. The foam does not absorb water. I bought the 59 inch length for additional use on the car. I did not however remember to measure the length prior to my first cut so could not state if it was accurate. I got the 1/4 depth, and it was accurate as well as the width at 12 inches. I had no issue peeling the backing, nor any issue of the adhesive coming off the foam.

Car stereo installer here. Its often hard to know by the pictures which neoprene rubber foams have the open pores (still ccf) to tackle rattles and not make them worse, this is the stuff. Its nice and stretchy too, so sticking to curves or tight turns is a breeze. Didnt have any issue with peeling the backing paper as others have mentioned, maybe they got an old batch.

It says rubber but it’s actually foam. So this listing is a scam. You don’t get a rubber adhesive mat. ITS CHEAP FOAM

As the result of a freak accident (dont ask!), the hard plastic hood of my John Deere riding mower was badly damaged. I collected the pieces and clamped them back together. Next, I cut large pieces of the adhesive-backed foam and carefully placed them over the damaged areas on both the inside and outside of the hood, sealing the broken plastic pieces together on both sides as close as possible to their original positions. The underside of the hood is black, so the black foam matches perfectly. For the outside of the hood, I followed up with a couple of coats of spray paint in John Deere Green. From a distance, it looks perfect, and up close, its not bad. The adhesive seems to be holding up beautifully! (Sorry I dont have a photo or two!)

I bought this to pad the liner of a hat to make it slightly smaller. It fit just right and works perfect. The Neoprene acts as a barrier and helps protect the hat fabric from becoming sweat stained.

Nice rubber and adhesive but is not damp or waterproof. Rubber peels away with only the slightest moisture. Unfortunately it is of not use to me now.

Sticks and grips great!

This is great for crafts and easy to cut. It’s made a very good quality and jet black.

Very good stays put