Aokin 3D Printer Hotend Silicone Sock Heater Block Silicone Cover for Creality Ender 3, Ender 3 Pro, Ender 5, Ender 5 Pro, CR-10/10S, Anet A8, MK7/8/9 Hotend, Blue, 3 Pcs

These work okay. I dont think they work as well as the original tape and insulation. However, they were much easier to install. I am using on a Monoprice Mini (I think it is the first model). They dont fit exactly right but arr good enough. They did smoke a bit (@250c). That only happened for the few minutes though.

Despite being a top search result for Anycubic Vyper silicon sock, this does not fit.

Perfect fit

This sock is built differently from a original. The original has 3 solid walls, This one has 2 plus one with a rounded (wire?) cutout. That cutout make it weak to stay in place. I find the front is drooping because it will not stay connected at the top. The shelf overhangs are more flexible because of that hole. Get the Creality Original.

These are great to have to prevent heat block buildup. They also make clean up easier whenever messes happen.

Fits perfectly on my replicator 2 and hasnt fatigued a bit in the last 100 plus hours of printing.

These work perfect on my stock Creality Ender 3 Pro hot end!!

Does not fit Ender3 inner diameter is not 20mm

I bought a CR10 from a friend. I noticed the silicone boot was missing, so I ordered this 3 pack. Quality of the boot seems ok, but it won’t stay on the nozzle block. If it does stay on, it hangs low enough where some stringy PETG will definitely pull it off. Going to return these and buy the originals from Creality.

buena pieza de reemplazo