Atwood 93868 Water Heater Replacement Parts - Spark & Sensor Electrode, 2-Prong (1)

My RV water heater would not light. This was the most probable cause so I replaced it with this one and it fired right up. Easy 10 minute fix. The part was an exact replica of the original.

Works fine

Worked great, had no issues

It does not have the protective boot on the wire, so if any rain or dirt gets in I will have to replace more than this part. Would not recommend ordering this part. Another reviewer posted a picture and mine is just like that one. Stay away.

the PROTECTIVE rubber boot on this item is not the correct one and it will not fit your water heater. Also the porcelain tip does not have a seal as the original does. It is not the same item as in the picture it is a very cheap knock off that will not work correctly. Such a waste of my time to sell items that are misrepresented.

This, along with the new thermostat I bought, was an easy way to clean up and restore my old water heater. Works great. Only problem is it did not come with the cap for the connection where I plug into the circuit board, which is not possible to take off the old one without destroying it. But other than that, it works great

This igniter fits perfect in my Atwood Water Heater. Very simple to install.

Worked like it should. Didn’t fix my problem, ended up being the board, but now I have a new igniter and a spare one.

The original screw hole on my Dometic/Atwood Model# GC6AA-10E is not the same size as this replacement so I had to drill it out and then just ended up replacing it with a washer, but, and screw. Original screw was just a worthless sheet metal screw that barely held it in anyway.

I like the fit as it worked out nice for my 2004 coachman freedom series. Youll need a small socket to install ignighter ,believe it was 1/4 .