

Atwood 93868 Water Heater Replacement Parts - Spark & Sensor Electrode, 2-Prong (1)
-
Mason Montgomery
> 3 dayThis, along with the new thermostat I bought, was an easy way to clean up and restore my old water heater. Works great. Only problem is it did not come with the cap for the connection where I plug into the circuit board, which is not possible to take off the old one without destroying it. But other than that, it works great
-
Dave Tyerman
> 3 dayFit perfectly just like the original.
-
tom
> 3 dayInstalled and working great
-
Chris
> 3 daythe PROTECTIVE rubber boot on this item is not the correct one and it will not fit your water heater. Also the porcelain tip does not have a seal as the original does. It is not the same item as in the picture it is a very cheap knock off that will not work correctly. Such a waste of my time to sell items that are misrepresented.
-
Ray Hogaboom
> 3 dayReceived parts in the timing manner
-
Navy Seabee
> 3 dayEasy to install save me 150 dollar service call
-
SJ
> 3 dayDid not fit our model of hot water heater
-
Kenneth T.
> 3 dayWorked great
-
Allan Newton
> 3 dayThe part was identical. Install quickly
-
Frederique Mayer
Greater than one weekOur Atwood GC6AA-10E water heater would go through 6 to 8 start ups, where it would spark, light and burn for 2 seconds and go out. Then after that it would start and work. But it would fail again. after overnight cooling off. Guessed that there was no milliamp voltage from electrode. being fed back to control board to keep the gas on after lighting. This new electrode seems to have solved the problem. Starts like a champ now. Lucked out it was not the board.