Brush Research FLEX-HONE Cylinder Hone, BC Series, Silicon Carbide Abrasive, 3 (76 mm) Diameter, 240 Grit Size

East to use great tool for the price.

I have personally relied on products from this company for a very long time in a professional setting. As far as ball Hones go Flex-Hone is the best and has been. The quality is top notch and the number of sizes they make are unequalled by any other company

Used this for refinishing a plow piston cylinder. A lot of people complaining about the price but this is much cheaper than any other available option, whether sending out to get machined or buying and actual hone setup for at home.

This was exactly what I needed at a VERY affordable price. Came in 3 days!! Wicked F A S T shipping!!

Used this for my Predator 212cc go kart build, where I was swapping to a flat top piston for additional compression. While the cylinder didn’t look bad to begin with, this hone made it look great. I coated the hone in oil and utilized it for around 30 seconds per the instructions. Can’t wait to use its again on the next build!

Worked great

If you are only a tiny bit over the nominal size do not follow the instructions and go up one size. They are oversized to begin with (my 1 1/8 hone being a few thousandths shy of 1 1/4). I bought a 1 1/8 hone to remove the seam from 1 SCH40 pipe and open it up from 1.03 to 1.06 so that 3/4 pipe will telescope in structural applications. I also intended to use it to open up 25mm aluminum C-cell flashlight tubes to fit 26mm LiFePO4 cells (1.026). I am hoping that after breaking in the hone on the steel pipe I will be able to start it in the aluminum tube without damaging the end. I think in both cases I would have been better served in not following the instructions and buying the 1 hone instead.

There was nothing to dislike safe and easy to use takes guesswork out of cylinder honing

Was easy to use

Perfect product, great description about getting the right size for my cylinder. Thanks