Creality Capricorn Bowden Tubing 1M, Bowden PTFE Tube for 1.75mm Filament with Teflon Tube Cutter, 2X PC4-M6 Extruder Fitting & 2X PC4-M10 Hotend Fitting for Ender 3 V2/3/3 Pro/5/CR-10/10S 3D Printer

Allows filament to push through much easier to the extruder, and allows for faster print and retraction speeds

Always good quality.

See the headline, I am not able to use the item at this time.

Come fast and was what I needed.

Do you have extruder issues? did you improperly change or move filament in the tube? are you scared that there is something happening in the tube that is causing you to think something is stuck in there? get this and install it. I was facing a lot and i mean a LOT of issues with the original tubing on my printer, but after changing out the extruder, and THEN the tube, I saw a clear jump in quality of my prints. While you could say that bad filament shavings could have worn down my tube, I feel in my heart that this is a necessary upgrade in the long run. the peace of mind that i have in knowing i can basically print any filament at a regulated temp without fear of weird heating makes this purchase worth it. oh, if you feel like there is tension in your printing, another fix you can try is to print out, or have someone print for you, a TUSH spool holder. That way you are reducing as much friction of possible as you pull that filament from the spool through the extruder and when it retracts. get this if you need a tube. I print reliably and understandably right now at a max of 245 for my hatchbox petg. if this was helpful for you, or if you have any further questions, let me know.

Great quality. Must have accessory.

Worked great glad I got the fittings too

Put in some 1.75mm Petg filament and it is a very tight fit with Lots of friction. Wasn’t really usable but I didn’t check the fit before cutting it so in the trash it goes.

Great product and fast delivery

Has to replace the nozzle on my printer and wanted to replace the Bowden tube while I was at it. ( During the process also calibrated my E-steps). Just lines up the old tube to the new roll, used the supplied cutter which cut straight and easy. Swapped the fitting on the hot end and fed the new Bowden tube in while the nozzle was 1 turn out. Tightened the nozzle and off we go! Feeding any filament through this is so much smoother. The inner diameter is a closer tolerance to the filaments I use as well as it is very slippery. Feeding filament by hand through this tube is almost effortless. For the money, this has to be one of the cheapest and best bang-for-the-buck upgrades to my printer next to bed levelling springs. I even have enough left over to do my friends printer, with some left over. If I need this again for whatever reason, I will get it again.