CTEK (56-304) Comfort Connect Extension Cable, 8.2 Feet

Bought this together with a NOCO GC004 X-Connect extension cable. After some DIY grafting, the CTEK charger can hook up to some NOCO accessories and vice versa. The CTEK extension wire is a thinner gauge compared to the NOCO wire though, and this CTEK extension cable does warm up slightly under a full 10A charging current.

I bought these extensions to not only extended the cable, to eliminate wear and tare on the main connector on the Ctek unit itself

Very helpful due to the layout of the power outlets in my garage. Excellent.

Easy hook up to permanent battery contact. Just snap in place at both ends.

The plug fits perfectly into the existing CTEK charging cable as expected. Not much more to add. If you need additional length in your charging cord, then this is the extension cable to buy.

I expected the same wire for this extension as the wiring on the CTEK unit. It is no, it is more rigid than my 7002. The 7002 also uses 16awg and the extension is 18awg, disappointed in that as well!

I wish the listing would have noted that the quick connect part of the charging was included AND how long it was. There was only mention of the cable that temporarily clamps to the battery posts, which in most instances I would only need to use on rare occasions. The included quick connect with the charger is plenty long enough and this was not really needed. Having said that, it is nice to know that I can reach the quick connect on my motorcycle from just about anywhere in the garage and dont need to move the charger to different power outlets. It will also attach to the previously mentioned clamps as an extension, so if I want to clamp onto my 4x4 pickup truck battery I can easily reach it and connect to the charger so that I can place it and see the state of charging/reconditioning. Easily worth the nominal price for much added convenience.

Nice fit for your Ctek charger. Now I can reach perfectly the cigarette lighter receptacle located in the medium console of the car with a lot of cable spare, so my battery tender is affixed to the wall. Recommended for a Ctek product.

Installed this cable to hardwire my battery tender to my Jeep. I used the M10 eyelet connector and wired them together. I used the rubber protective cap to protect the end of the cable that was exposed to the elements.

Just what I needed, purchased a CTEK 560352 to connect to the car battery, mounted the CTEK Battery Tender on the wall close to the AC outlet, and used the extension cord to connect the two. Made cable management a breeze, the added resistance load due to the longer cable was a concern but the Battery Tender so far has been able to cycle through its various charging/tender modes without any issues. Will keep an eye on the tender to see if the longer cable has any effects in regards to longevity.