E3D Genuine Heater Cartridge - 24v 40w (E-HEATER-24V-40W)

I made sure I bought from the vendor others recommended to get a legit one. Works well when I needed to replace my heater cartridge on my MK3s. Would buy again if I need a replacement.

This works well in my Prusa i3 MK3S. Theres not much more to say than that. It replaced the one that my printer came with after I broke the connection to the old one when trying to hot tighten my nozzle. One thing to note is that I was sent a white one, not a red one as shown. I dont know if the items description says colors may vary, or not. And, really, how much of the cable do I see? And, really, do I even care? Also, Ive noticed that the hot end tends to shoot past the target temp by about 2-3 degrees C before settling back down. I dont remember if the old one did that, so Im just assuming it did, and that this one is no different.

I chose an authorized reseller for this item. Mine was the white one and it works great on my Prusa MK3S+. The cable on this is a little longer than the original but its not bad.

Of the two that I ordered the one that was actually a 24v cartridge works as expected. The second one that I ordered had a label of 24v on the card in the package but was actually a 12v cartridge. I didnt check the label on the cartridge before installing it in my printer and spent a ton of time troubleshooting before I took it back out of the printer and realized that it was the wrong version. I requested a replacement because I want a spare and the second one that was sent was also labeled as 24v but was again a 12v. I then had to spend time running all over town returning the two 12v cartridges because for some reason Amazon would not let me return both of them at the same location.

The quality of construction looks superb. The problem is the photo in the listing does not match what is shipping. The wires are white, BUT, it does not have the right angle feed into the cartridge, and more importantly, it does not have the plug as shown to detach quickly when swapping a hotend.

I updated my hot end from 12v to 24v and this has been running strong.

Busted heater on a prusa (24v system, E3Dv6 hot end). This fixed it right up. Nice long cable, with the ends helpfully ferruled

Luke others have said, not as described but functions as intended.

As described

heats as fast as the original one i had, but it should.