Ender 3 Hotend, Authentic Creality Assembled Hotend Kit 3D Printer Parts with 5X 0.4mm Nozzles for Ender 3 Ender 3 V2 and Ender 3 Pro

Works well but the cables at the heater end were very stiff and feared they would break. Especially the thermo sensor wire. Once installed, worked well.

Youll need to take apart a part of your 3d printer for it so make sure you know what you are doing.

Had to replace the old hot end since i done goofed up the original one while changing the nozzle. It is as simple to install as it is to remove it. I did keep the original heating element and thermistor since those still work (and so I dont have to re-route wires n stuff) Does everything exactly as the original, so nothing else to comment on. 10/10 NOTE: Buyer do read/see what it comes with. It does not come with the fitting to connect to your filament drive in case you needed to replace that. Thats all folks.

I liked that this is a direct replacement of the stock ender 3v2 hotend. I had failed print that had all the pla getnstuck to the hot end and caused the thermistor wire to break. Since I do not use this printer but only for PLA I just went stock.

Good quality stock replacement for ender 3 pro

My printer canes back to life, it works exactly as the original

Works as intended on my Neptune 2S

This hot end replacement for the Creality Ender 3 printer looks to be identical to the original hot end, which was a nice surprise. The heat block is silver on the product I received as compared to the gold/brass shown in the photo, but this also matches the original hot end, so thats a good thing. The entire hot end came pre-assembled and well done at that. Some people recommend removing the screws on either side and claim they are just part of the assembly process, but I have been using both the original and replacement hot ends with the screws intact and have not had any issues. This is a good-quality, authentic, exact drop-in hot end replacement for the Creality Ender 3. I highly recommend it.

Purchase arrived in good condition.

I can see why these parts are commonly replaced especially as a new user after about 9 mos of heavy printing. You do make a lot of mistakes haha. For my first time replacing something like this it was a bit of a bear for me. Lots of patience and pausing videos. Seems to work really good after a few weeks so far. My heat monitor fluctuates about + and - 5 degrees constantly. The only effect is that it takes a while to load/unload, and a bit longer to start a new print. Like the mother board is trying to decide if it’s hot enuff or no not. I would purchase it again though. Been having great prints with almost no issues.