Ender 3 Hotend, Authentic Creality Assembled Hotend Kit 3D Printer Parts with 5X 0.4mm Nozzles for Ender 3 Ender 3 V2 and Ender 3 Pro

I liked that this is a direct replacement of the stock ender 3v2 hotend. I had failed print that had all the pla getnstuck to the hot end and caused the thermistor wire to break. Since I do not use this printer but only for PLA I just went stock.

Had to replace the old hot end since i done goofed up the original one while changing the nozzle. It is as simple to install as it is to remove it. I did keep the original heating element and thermistor since those still work (and so I dont have to re-route wires n stuff) Does everything exactly as the original, so nothing else to comment on. 10/10 NOTE: Buyer do read/see what it comes with. It does not come with the fitting to connect to your filament drive in case you needed to replace that. Thats all folks.

This hot end replacement for the Creality Ender 3 printer looks to be identical to the original hot end, which was a nice surprise. The heat block is silver on the product I received as compared to the gold/brass shown in the photo, but this also matches the original hot end, so thats a good thing. The entire hot end came pre-assembled and well done at that. Some people recommend removing the screws on either side and claim they are just part of the assembly process, but I have been using both the original and replacement hot ends with the screws intact and have not had any issues. This is a good-quality, authentic, exact drop-in hot end replacement for the Creality Ender 3. I highly recommend it.

So far so good havent had any problems yet

If clogs way to easy.

Finally getting around to swapping out hot end and unfortunately the feed tube was way to short to allow for normal operation. Now waiting for replacement tubing to complete the swap. Will update when I atually start using.

Left the printer, came back to plastic tumor. Replaced with product and had no issues. 10/10

I can see why these parts are commonly replaced especially as a new user after about 9 mos of heavy printing. You do make a lot of mistakes haha. For my first time replacing something like this it was a bit of a bear for me. Lots of patience and pausing videos. Seems to work really good after a few weeks so far. My heat monitor fluctuates about + and - 5 degrees constantly. The only effect is that it takes a while to load/unload, and a bit longer to start a new print. Like the mother board is trying to decide if it’s hot enuff or no not. I would purchase it again though. Been having great prints with almost no issues.

Works great but having issues with it working just right with the glass table I put on so I had to put the original back on and it works fine

I bought this as a replacement for the stock creality printed for the industry Pro I was hoping it wasnt upgrade but it was actually a downgrade Ive had this now for a little bit and I printed quite a few things the biggest thing that drives me crazy is this hot and comes apart constantly after every print I have to tighten up every screw Im not sure why it does this no other print head has ever done that for me