HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

3 stars because the product works, however the wires are significantly shorter at about 100cm than the stock heater cartridge at about 146cm wire length. Ill probably only have use of about 75% of my z space until I find a longer one to replace this one.

Fail, fail, fail... think you guys can put the same connectors as what is on your printers. Or just leave as bare wire. About to rewire the whole printer using connectors from PCs. At least then they will be easier to work on and interchangable

drop in replacement no issues

Out of the 3 pieces ordered only 2 look usable. 3rd piece had a damaged metal core with only 1 wire, not 2 coming out of it and the 4th was just a single wire with no core. At this point I’m concerned about whether or not to even try the 2 “good” ones to see if they work. Also the length of wires is not consistent.

The wire is about a foot too short to go from the board to the hot end on an Ender 3v2. I had to solder a length of wire to fill thengap

Was having ‘thermal runaway’ issues. Most likely the thermistor, but I replaced both, and prints have been coming out great ever since!

Replacement for a failed cartridge in my SV03. Been printing now for 24 straight hours and temp has been steady!

All 3 ohm out good around 14.5ohms, but they are only 39 inches long. Stock heater is 56 inches so its just over a foot short of reaching when sleeved with the rest of the wiring.

These are about 8 inches shorter than the stock cables.

Seem to work very well, and cant beat the price. Heats to print temperature in under a minute with a good quality power supply, still using the first one after months on the printer but nice to to have spares handy.