HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Had thermal runaway on my CR10S PRO V2 so replaced thermal couple and 40W heater. Turned out to be software and hex file issue. Got new updated software from Tiny Machines. Now heats to 300C with no issues.

Out of the 3 pieces ordered only 2 look usable. 3rd piece had a damaged metal core with only 1 wire, not 2 coming out of it and the 4th was just a single wire with no core. At this point I’m concerned about whether or not to even try the 2 “good” ones to see if they work. Also the length of wires is not consistent.

All 3 ohm out good around 14.5ohms, but they are only 39 inches long. Stock heater is 56 inches so its just over a foot short of reaching when sleeved with the rest of the wiring.

I had to replace my heater cartridge for my Prusa mini and it worked fine. Install was quick. Make sure you have a wire ferrule for the endpoint to connect the cartridge to the printer.

First off, the cord is long enough to reach MB case using the previously routed cable guide. Fit my STOCK hotend from my ender 3 v1. works as advertised. did not have temp gauge to check for accuracy.

works as expected.