HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Fail, fail, fail... think you guys can put the same connectors as what is on your printers. Or just leave as bare wire. About to rewire the whole printer using connectors from PCs. At least then they will be easier to work on and interchangable

Great product! As advertised!

Was having ‘thermal runaway’ issues. Most likely the thermistor, but I replaced both, and prints have been coming out great ever since!

Replacement for a failed cartridge in my SV03. Been printing now for 24 straight hours and temp has been steady!

These are about 8 inches shorter than the stock cables.

works as expected.

Had thermal runaway on my CR10S PRO V2 so replaced thermal couple and 40W heater. Turned out to be software and hex file issue. Got new updated software from Tiny Machines. Now heats to 300C with no issues.

The heating element on this is shorter than the OEM one. But i havent seen it cause any issues yet. But the harness is REALLY short. So when you cut your original one to splice it, make sure you cut a decent amount of excess off.

Seem to work very well, and cant beat the price. Heats to print temperature in under a minute with a good quality power supply, still using the first one after months on the printer but nice to to have spares handy.

All 3 ohm out good around 14.5ohms, but they are only 39 inches long. Stock heater is 56 inches so its just over a foot short of reaching when sleeved with the rest of the wiring.