HICTOP Ender 3 Heater Cartridge 24V 40W 1M/39.4Inch for Creality Ender 3 Ender 3 Pro Ender 5 CR-10S Pro 3D Printer Prusa Mendel （Pack of 3）

Fixed my hotend.

Out of the 3 pieces ordered only 2 look usable. 3rd piece had a damaged metal core with only 1 wire, not 2 coming out of it and the 4th was just a single wire with no core. At this point I’m concerned about whether or not to even try the 2 “good” ones to see if they work. Also the length of wires is not consistent.

Fail, fail, fail... think you guys can put the same connectors as what is on your printers. Or just leave as bare wire. About to rewire the whole printer using connectors from PCs. At least then they will be easier to work on and interchangable

Here is an item that works perfectly. Make sure your psu is 24 volt.

The wire is about a foot too short to go from the board to the hot end on an Ender 3v2. I had to solder a length of wire to fill thengap

Great product! As advertised!

Fast shipping, worked perfectly.

3 stars because the product works, however the wires are significantly shorter at about 100cm than the stock heater cartridge at about 146cm wire length. Ill probably only have use of about 75% of my z space until I find a longer one to replace this one.

works as expected.

These are about 8 inches shorter than the stock cables.