











KFD 4 PIN Adapter Compatible With Synology DiskStation 4-Bay DS412 DS413 DS414 DS415 DS710 DS712 DS416 DS416j Ds416play DS416SLIM DS418 DS418j NAS Server Diskless Network Attached Storage Power Supply
-
Sterling Johnson
> 24 hourSo far so good!
-
Whateva
> 24 hourThe adapter worked properly to power a Synology DS918+. The original OEM power supply still displayed a green light but was unable to sufficiently power the Synology to allow it to start. This replacement adapter allows the Synology to start and run properly.
-
LP
> 24 hourDevice delivered on schedule, powered diskstation as expected.
-
jazix
> 24 hourMy DS918+ power brick died after just under five years of use, and this one works perfectly as a replacement. Its been going for just over a week with no issues.
-
Billy Bob
> 24 hourMy Synology was randomly powering off for unknown reasons and then, one day, decided to turn off and never come back. I suspected the power adapter immediately and jumped onto Amazon to order this replacement. While the connector to the back of the Synology was a bit tighter than the OEM, it went in fine and as soon as I connected the power, my Synology came back to life! While its too early to tell about longevity, this adapter feels very solid and should last for at least as long as the original (5 years).
-
ynpmoose
> 24 hourPower supply had died on my DS916+ and this fixed it.
-
Billy Bob
> 24 hourMy Synology was randomly powering off for unknown reasons and then, one day, decided to turn off and never come back. I suspected the power adapter immediately and jumped onto Amazon to order this replacement. While the connector to the back of the Synology was a bit tighter than the OEM, it went in fine and as soon as I connected the power, my Synology came back to life! While its too early to tell about longevity, this adapter feels very solid and should last for at least as long as the original (5 years).
-
ynpmoose
> 24 hourPower supply had died on my DS916+ and this fixed it.
-
Andrew
> 24 hourDreaded flashing blue light on my DS918+. Unit would boot up without any drives and also with a 2.5 SSD so motherboard looked ok. But as soon as any 3.5 drive was inserted the unit would fail to start successfully and reboot (when trying to power up the drive a few seconds in). Replacing the power supply with this KFD unit resolved my issue.
-
Althea Hodkiewicz Jr.
> 24 hourSo far so good!