Metal MIC HOLDER / Clip - Screw In for CB / Ham Radio - Workman MH2

Brittle steel. They were too tight to fit our mics. They should have been spring steel which would tolerate a little fixing into shape. 3 broke when trying to spread open the fingers.

Works just like the last one. Traded trucks and bought this one.

I attempted to bend the middle tab out a little bit to better fit the microphone of my Cobra 29LX and it snapped off with just the first motion. Go for the Motorola one, its a little bit larger but it is so much better quality and about the same price.

Easy to install

Good quality as described.

Its a typical mic hanger. What is there to say?

I bought this to mount on the side of my Cobra 29 CB. The only issue I had was the screw not tightening up all the way. I used existing holes in the side of the CB and apparently the screws that come with it are too long or something so it is loose on the side of the CB. It does still work fine and Ive not had any issues with it.

I needed a couple of these for a project in the car and also one for a mic in the hamshack. These worked and solid metal. No issues here.

Fits my mic perfectly. Would give it 5 stars if spring tension in unit just a little tighter and metal a little thicker.

The supplied mounting screws do not fit in the body of the CB Where you are supposed to mount the fork too Too big of a thread I ended up taking my case screws out and the out and using those mounting sideways Wish I could have monitored horizontal