

















[Pro Version] KIWI design VR Cable Management, 6 Packs VR Pulley System fits Quest/Rift S/Valve Index/HTC Vive/Vive Pro/HP Reverb G2/PSVR/PS VR2 VR Accessories, Compatible with Quest 2 Link Cable
-
Flame Soulis
> 24 hourI previously was using another cable management system that was slightly cheaper, which did the job fine but had higher tension and twisted metal cables. Finally, one of the cables snapped and rendered the pulley useless and I was forced to buy another set. After ordering these, I replaced my older set with the KIWI versions and havent looked back. Not only are these sturdier, but are set up just to work for cable management. Other pulley systems are set up as bundles of ID card pulleys, but these actually are designed to hold cables thanks to the cable holders at the ends. In addition, the tension and pulling force is just correct: not too much but not too weak. Are these more than the others? Yes, but the extra price you pay is worth the premium.
-
Eduardo Jimenez
> 24 hourKeeps my cable off the floor and helps with mobility. One of the sticky pads came off the ceiling early on but I pressed it back on harder on a slightly flatter spot and so far all of them have stayed up for several months. If I had a more permanent VR space I would drill them in but these sticky pads are good enough for now.
-
Caleb
> 24 hourBought these for my Index and so far I like them. Ive been looking for something to get the cord out of the way and this is it. I havnt gotten alot of use from them yet so I cant say how long they will hold up but they seem pretty solid. Does exactly as advertised. I no longer am stepping on my cord and the pull strength is just right. I dont feel the cord or tugging on the cord and there is no noise that I can hear. About as close to a wireless feeling as you can get.
-
Jonathon W. Jenkins
> 24 hourNo way this sticks to anyones popcorn ceiling, but overall everything else is perfect
-
Aaron D.
> 24 hourThis is an amazing and cheap product. Ive messed around with wireless adapters but theres always issues with heavy batteries, disconnects, extreme expense, etc. This product is amazing though. It only took me about 5 minutes to set up and after playing with the length of the cable, I can barely feel any sort of tug unless I get right to the edge of my play area. Flat ceilings work best but theres a solution for popcorn ceilings as well. Theres no way I can go back or even consider a $300 adapter after trying this.
-
Christopher Sommer
> 24 hourThese things are amazing! Just the right amount of pull to keep the cables out of the way without impacting your experience. You can really just get into the game and forget youre tethered to your computer in anyway. The suggested set-up is great and all, but honestly the individual units work so well that you probably dont even need to use the multi-unit end-point. Unless you have a larger space, which would likely help there!
-
Contrabardus
> 24 hourThey work great, perform as advertised, and keep my chord out of my way. I cant drill holes in my apartment, so Im using the sticky pads. I actually have one of them on the blinds of my window to get the chord above the floor, and three attached to the blades of a ceiling fan. When I move and need to take them down, I should be able to do it with a hair dryer to warm up the glue enough to pull them down without damaging anything. Its very strong adhesive, not gorilla glue or anything, but they wont come off easily once set. They arent going to pull my fan down or disrupt it. Putting the thing in reverse mode so it pulls air instead of blowing it will put more downward force on the fan than these things generate while in use, and they are easily unhooked. I cant use the fan anyway when playing VR as I risk putting my hands into them and breaking my controllers. Its barely low enough to allow that to happen if Im aiming close to straight up, which I occasionally do in some games. The stickers are large is, at a couple of inches square, but not nearly enough weight to unbalance the fan, and the hooks that the pulleys attach to dont cause any problems. I think perhaps people complaining about too much pull arent using enough of them. The more you use, the more the weight is distributed, and the less pull there is. I generally use four at a time, which is enough to support the weight of my Index cable. I also recommend not putting them on as tight as they will go on, as I think that is what is damaging some peoples cables. I use the second slot so they can slide a little. It still holds the cable in place while in use, but I can push them to where I want them if I want to adjust something. I generally dont feel them until I bend or crouch down, and even then barely. Certainly not enough to displace the HMD. I was using a couple of jerry rigged dog collars before I got these and they were way worse. This works as a solution to getting your VR cabling off the floor and out of your play area. Its not perfect, the only perfect solution would be wireless, but for PC VR for high end PC VR that doesnt have a wireless solution yet, these do the job. Recommended.
-
Doomsauce
> 24 hourThis functions great as a product to keep cable weight off ones self, but if you are a more ambitious VR enthusiast these are recommended with caution. I have a standard ceiling and I had a handstand go wrong with my foot getting caught in the line. All would have been fine but the length of the system does not reach the floor and caused a mishap with landing. The cable management broke and I have a damaged foot. Also the pull of the cables is on the weaker side and I would recommend about 9 if you want a taut system.
-
Jack Ryder
> 24 hourColor Me Impressed! I was looking for a good way to keep from getting tangle whilst amidst the virtual worlds and what not, so i did a quick search and found these bad boys! I have to say the quality certainly is there. the actual cable holders do a great job of supporting the cable without resistance when you move around. Something else I do greatly appreciate is the inclusion of multiple mounting options instead of just sticking you with cheap adhesive hooks. This instruction are good as well. They do a great job of explaining everything you need to know. I can not recommend these highly enough! A mist buy for sure.
-
Tims944
> 24 hourThese are great. Keeps the cable off the ground and more out of the way. Only way they could be any better is if they were just a little weaker cause it does pull a little more on the cable than I would like, but honestly is probably still less wear than me stepping on or tripping over it. Oh I used the hooks so I don’t know how well those will work but the anchors and hooks hold well.