SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)

Excellent

Used this in my hand held air grinder. Works amazing, sharp, cuts great, proceed right, easy yes to buy this EM

Im new to milling and this bit is the best one I have used so far. Ive order one from a different company that was the best money can buy and unfortunately it didnt hold up to the speed tiger

Worked perfect was cutting 1/4” key way in stainless steel shaft cut like butter great product

I will buy more from this company. Compared to what I have been using this tool is amazing.

I ran 100pcs at 5000rpm, 80 ipm and dry no coolant with .055 radial cut at 1 deep, 2 endmills did the whole job! Dont believe take a look at high speed machining on SS on the tube!

Excellent product, I was able to run an entire difficult job in stainless with them. Will buy again for sure.

works great in stainless st

Ive gone through my share of endmills and they always burn up as with a 24k rpm spindle, going less than 3000RPM is not easy as the torque available is almost nil. I bought one of these for hardened steel and stainless steel I needed to mill and this endmill Ive got actual cutting time so far 6 hours contact in hardened steel and 11 hours in stainless steel total and this still cuts like a hot knife through room temperature butter. 3137 rpm at around 650mm/min works great in either metal. 1st order from this company and wont be my last, in fact all my purchases will be from this company.

Great end mill for the money. Only used on aluminum, dont know how it will work on steel.