

SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)
-
jt
> 3 dayIm new to milling and this bit is the best one I have used so far. Ive order one from a different company that was the best money can buy and unfortunately it didnt hold up to the speed tiger
-
Justin Kwasny
> 3 dayIve gone through my share of endmills and they always burn up as with a 24k rpm spindle, going less than 3000RPM is not easy as the torque available is almost nil. I bought one of these for hardened steel and stainless steel I needed to mill and this endmill Ive got actual cutting time so far 6 hours contact in hardened steel and 11 hours in stainless steel total and this still cuts like a hot knife through room temperature butter. 3137 rpm at around 650mm/min works great in either metal. 1st order from this company and wont be my last, in fact all my purchases will be from this company.
-
melissa norman
> 3 dayworked like a champ
-
ROY WHITEMAN
> 3 dayGreat end mill for the money. Only used on aluminum, dont know how it will work on steel.
-
Aiden Streich
11-06-2025Great endmills. One 5/16 has milled the outside all of these in 304 stainless and still running.
-
Toon
> 3 dayI ran 100pcs at 5000rpm, 80 ipm and dry no coolant with .055 radial cut at 1 deep, 2 endmills did the whole job! Dont believe take a look at high speed machining on SS on the tube!
-
Jeff W
> 3 dayCuts well and stays sharp
-
Stefan Molnar
Greater than one weekGood endmill for price, will buy again
-
Family Account
> 3 dayI will buy more from this company. Compared to what I have been using this tool is amazing.
-
Douglas H
> 3 dayUsed this in my hand held air grinder. Works amazing, sharp, cuts great, proceed right, easy yes to buy this EM