SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)

Used this in my hand held air grinder. Works amazing, sharp, cuts great, proceed right, easy yes to buy this EM

I ran 100pcs at 5000rpm, 80 ipm and dry no coolant with .055 radial cut at 1 deep, 2 endmills did the whole job! Dont believe take a look at high speed machining on SS on the tube!

I use this as a router bit and its incredible. Ive routed fir, oak, mahogany, aluminum, brass, and thin mild steel. After 3 months of occasional use (only about 5 minutest a day averaged out) its still about as sharp as new. I use it primarily to open up strike plates for customers whose doors arent closing properly and its been a godsend. Try it out; what have you got to lose?

became full after lite use with aluminum

Great endmill. Use on 316ss. I never do reviews but had to say something about these guys

I have used these on aluminum and stainless steel. Aluminum is butter, SS needs a slower feed rate.

This endmill cut .06 deep flats on 304 stainless 800 times. Then cut some plastic because I was too lazy to change it out. Cut like butter. Nice product!

Ive tried at least a dozen carbide tipped cutters (reciprocating blades etc.) that claimed to cut cast iron, all of them dulled or broke (lost teeth) after 6 or 7 cuts (up to 3/16 thick). Yes, at slow speeds with cutting oil. This is the only one that still cuts after dozens of uses.

Works good