

SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)
-
sheryl keon
> 24 hourPerfect as described
-
Stefan Molnar
> 24 hourGood endmill for price, will buy again
-
Charles Williams
> 24 hourI used a lot of cutting oil, but this done the job I needed it to do. Very, very happy with this end mill. Fits perfectly in my drill press.
-
Lynn Strub
> 24 hourproduct worked as expected.
-
Chris
> 24 hourThis endmill cut .06 deep flats on 304 stainless 800 times. Then cut some plastic because I was too lazy to change it out. Cut like butter. Nice product!
-
Orthorex
> 24 hourExcellent product, I was able to run an entire difficult job in stainless with them. Will buy again for sure.
-
Aiden Streich
> 24 hourGreat endmills. One 5/16 has milled the outside all of these in 304 stainless and still running.
-
Soup Cook
> 24 hourIve tried at least a dozen carbide tipped cutters (reciprocating blades etc.) that claimed to cut cast iron, all of them dulled or broke (lost teeth) after 6 or 7 cuts (up to 3/16 thick). Yes, at slow speeds with cutting oil. This is the only one that still cuts after dozens of uses.
-
james sinema
> 24 hourExcellent
-
LapinSangSue
> 24 hourI use this as a router bit and its incredible. Ive routed fir, oak, mahogany, aluminum, brass, and thin mild steel. After 3 months of occasional use (only about 5 minutest a day averaged out) its still about as sharp as new. I use it primarily to open up strike plates for customers whose doors arent closing properly and its been a godsend. Try it out; what have you got to lose?