







Thermaltake V-Tubler PETG Tube 16mm (5/8) OD 1000mm 4-pack
-
DG
> 3 dayGood clarity, consistent wall thickness and diameter, no leaks, easy to cut, easy to bend. So far I bought 3 packs of these, I think. All in 16mm x 1000mm. Definitely the cheapest option if you require long continuous runs. I also picked up some shorter pieces once from this other company that apparently has managed to corner the market on the pc coolant and is slinging their obscenely overpriced colored water all over Amazon, but never mind that. Their tubing is supposedly of really good quality, touted as a benchmark by some smart-looking folks online. Well, I can’t tell the difference. Both look as good as you can get without switching to acrylic.
-
Rj
> 3 dayThis tubing is super easy to bend. Came very clean and clear. Would highly recommend. Just make sure to check compatible fluids before hand. PETG isnt comparable with all coolant, specifically propelyne glycol
-
MM
> 3 dayThe tubes worked well. I took off 2 stars because there are many tiny scratches on the surface. Normally they are not really visible but if you use thermaltakes rgb fittings it will make every defect very obvious. They might polish out but I havent tried yet.
-
C Morgenthaler
> 3 dayDo not put inch measurements unless they are exact. I realize that they are listed also in millimeters, but if you are going to put any information regarding inches it Hass to be exactly right otherwise things don’t fit together perfectly and can leak. If you are an American I would strongly advise you to ignore all of the inch measurements. They are completely wrong
-
RetrOrigin
> 3 dayGreat price and quality. Working great with EK-HDC 16mm Fitting.
-
Maverick the engineer
07-06-2025Soak your insert in pure olive oil before you put it in the tube and heat the tube. That tube compresses the insert, no lubrication and you will not be able to pull your insert out! I tried some spray oil, but it contained water and fogged up the inside of the tube. Pure olive oil has 0% water, thus, no fogging. Also you can mark where to bend your tubes on the insert with a pencil mark. Just rub off the pencil mark easily.
-
Avinash
> 3 dayIt is what it is. Thats is its petg tubing
-
mjplatt
> 3 dayEach individual tube is in an individual plastic sleeve to prevent scratches. If you dont have one, order a heat gun as well to make the custom bends unless you are going to buy a lot of fittings. It takes practice to get the bends correct and you will have a lot of scrap, so order more than you will need.
-
James P.
> 3 dayGreat for longer runs tubes come with no scratches in them. If you dont already have you will need a silicon bending insert I purchased a alphacool 12mm (1/2) ID that work good to prevent kinks.
-
Attila
Greater than one weekBought 3 different brands for tubing (just due to shipping times) I had to finish the build in a few days. It turns out I felt Thermal take had the best clarity and easy of use. They came in long runs allowing for fun bends with no couplings. I highly recommend these