Thermaltake V-Tubler PETG Tube 16mm (5/8) OD 1000mm 4-pack

good stuff nice bends with no thermal bubbles

Great for longer runs tubes come with no scratches in them. If you dont already have you will need a silicon bending insert I purchased a alphacool 12mm (1/2) ID that work good to prevent kinks.

Bad petg quality, scratches everywhere

Best Petg

Soak your insert in pure olive oil before you put it in the tube and heat the tube. That tube compresses the insert, no lubrication and you will not be able to pull your insert out! I tried some spray oil, but it contained water and fogged up the inside of the tube. Pure olive oil has 0% water, thus, no fogging. Also you can mark where to bend your tubes on the insert with a pencil mark. Just rub off the pencil mark easily.

awesome product

I bought this and tubing from EK this week, and even though I think EK makes the best fittings, thermaltakes petg tubes take the cake. yes there both clear tubes, but thermaltake were just perfectly clear, and there packaging was much nicer, and it was cheaper. Very happy.

I got an ongoing project alot of trial an error with a Cougar Conquerer as this is my 2nd time with hard line cooling and this will allow the margin of error to be a little larger without breaking the bank, maybe some custom one off bends too! 4 tubes 3 feet long less than $30, Im all over that!

just adding to my arsenal needed longer pipe less joints less chances leaks

Works as intended