Thermaltake V-Tubler PETG Tube 16mm (5/8) OD 1000mm 4-pack
-
scott r
> 3 dayjust adding to my arsenal needed longer pipe less joints less chances leaks
-
dontfeedmyfish
> 3 dayThe quality and packaging is fantastic. However, the tubes have an inside diameter of 12mm, which is about 0.472, so it is not 1/2. Its close, but maybe not close enough if you need a full 1/2 (0.500).
-
Nate H.
Greater than one weekThis company make every excuse to deny a warranty.
-
david roberts
> 3 dayThey came in their individual plastic bags but a couple still managed to have some nice scratches and marks. I managed to make my bends where they wouldnt show. For the price I would definitely buy again
-
Helmut Rodríguez
> 3 dayI love this rigid tubing loop. Ill use it again without a doubt. I recommend for its quality, easy to bend and cut.
-
Drumlord29
> 3 dayDue to the size of my tower, I needed longer PETG tubes than the ones that came with my thermaltake c360 kit. These tubes are really long. One major issue I had was not having a long enough silicone insert to bend it. So I went in a hardware store and got an electric wire with the same thickness as the insert. Since its sold by the foot, I only spent less than $8 for 4 feet. Im sure there are long silicone tubes for bending out there but I did not want to spend a lot just for me to bend a tube.
-
Paul
Greater than one weekUse this for every build. Definitely recommend
-
Jesse Barlow
Greater than one weekEasy to bend with a little heat.
-
Madbaby
> 3 dayTL-DR: If the label says Thermaltake, turn around and run fast back the way you came. Thermaltake is junk. You will do better buying your pipe and fittings from Menards.
-
mjplatt
05-06-2025Each individual tube is in an individual plastic sleeve to prevent scratches. If you dont have one, order a heat gun as well to make the custom bends unless you are going to buy a lot of fittings. It takes practice to get the bends correct and you will have a lot of scrap, so order more than you will need.
