Whiteside Router Bits 1376B Bowl and Tray Bit with 1/4-Inch Radius 1-1/4-Inch Cutting Diameter and 1/2-Inch Cutting Length

Does a great job. Sharp and well balanced.

Great

Love this bit. Very stable and easy to manage in my router table. Makes a nice flat surface, doesn’t burn or chip out. At first I tried the 3/4” bowl bit but it was frustrating because the flat spot was too small. This has a nice large flat spot.

If youre like I was, you buy any tool you can afford. Save your money and dont waste it on some no name tool company. You get what you pay for.... Spend a little extra and you will get better, longer lasting tools that at the end of the day, will save you time and money. You dont need to buy a whole set, but buy the most common bits from Whiteside, and you will be a much better maker.

Get this bit if you are considering buying a bowl bit. You wont be disappointed.

In looking for a solution to speed up turning of pens with consistent size results a jig was tested. Very sharp and stable cuts were had.

Great bit and at a better price than many of its competitors. This bit is large and best used after removing material with a drill press. It leaves a clean surface which requires only minor sanding.

Solid looking bit. Cuts very smoothly and easily. I have only used it in cedar but so far so good.

I uses this product to cut an indention into a serving tray.

I must have 10 different Whiteside Router bits. Their my go to bits, period! I do have in addition Amana, Bosch as well brands. But find White the bit for Bowl and bit work especially. This bowl and dish bit is not sharp or the angle of machining is off. It started work on for a 10 inch pass then started skipping all over the place. The bit is on the way back to Amazon and most likely Ill get the same but that Im pretty sure will work as per its design. Very Dissatisfied in all my years of Woodworking Ive never had an issue with a router bit except for a few when I first started the hobby using Skill brand.... If you look carefully I used a different bowl and dish bit routing the the surface but staying away from the edge. Why because its not the type of Bowl but with the correct angle I want on the entire edge. You can see how the bit Im returning scored/burnt the surface and skipped all over. I would recommend to anyone thinking about purchasing a Whiteside brand of anything really not to be perturbed they normally make long lasting precise accessories for the pros or if your into using em as a Woodworking hobby.