Whiteside Router Bits 1541 V-Groove 60-Degree 1/4-Inch Cutting Diameter and 7/32-Inch Point Length

(0 Reviews)

Price
$20.51

Quantity
(10000 available )

Total Price
Share
39 Ratings
35
4
0
0
0
Reviews
  • AOH

    > 3 day

    Great bit. Cuts wood like butter and makes very clean cuts. Will buy again.

  • Tagwatts1

    Greater than one week

    It arrived on time. This was important as I had a deadline to meet. It did the job I needed and I will use and order again as soon as I wear this bit out. Cost-wise these are cheap enough, I will not spend time trying to sharpen them.

  • Cityvendor

    > 3 day

    This bit is great. Used it for 2 plus months daily in my CNC for hours at a time on clear pine. Worked like new everyday. Lasted VERY long. Just bought a Spe Tool it lasted literally 2 days on the same materials. Whiteside is the best.

  • C. Reed

    > 3 day

    Used this bit to replace a 60 degree v-bit that kept breaking off the tip. It ran flawlessly through 12-4x8 sheets of fir plywood at 1/16 deep. Afterwords examined the tip and cutting edge with a jewelers loupe and found it was almost as new. Highly recommend this for engraving and projects were a v-groove bit will break.

  • jb

    > 3 day

    This is my favorite vbit. The third flute really changes the quality of cut in mdf. Small details don’t sheer off and the bit is very quiet compared to the other V bits I tried. The photo with “your orders” and the review section is wrong. You get the more compact bit seen in the listing photos.

  • Gary Hill

    > 3 day

    As discribed

  • KalEL

    Greater than one week

    Clean edges sharp

  • The Bern

    > 3 day

    I was having a terrible time trying to do inlays in walnut/maple with my Whiteside 1502, all the male carves were being torn up. I ordered the 1542 and ran the same toolpaths and all I can say is WOW! I ran at 18K RPM and a feedrate of 80IPM and my inlays are perfect. This bit has 3 flutes, so I am guessing that is the difference. You will not regret adding this bit to your inventory if you do inlays.

  • R. Welch

    > 3 day

    Great bit!

  • Ernest L. Johnson

    > 3 day

    With two projects done so far but I am very pleased with the clean cut. Ive used it to cut decorative borders in hard maple cribbage boards. The bit cuts to a point with no flat spot on the end. Very happy with the bit.

V Groove bits are used for a variety of projects where a standard v point cut is desired. V Groove bits are available in 60 and 90 degree tips.

Related products

Shop
( 1977 Reviews )
Top Selling Products