Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

Llegó incompleto. Debían llegar dos fresas y llegó solo una dentro del empaque

Great item would but again

Now I know why they send extra bearings Bearing fell apart after minimal use Be careful and check bearings often Would not buy again

The bit does work but it is not strong enough to cut thick wood without chattering so if you want to cut 1 1/2 inch stock you may want a 1/2 shank bit

clean finish

Good variety of sizes. Works well... Still requires quite a bit of presure to drill hard resin.

Nothing to dislike. Its well made and has a quality feel about it. I have used it to drill small holes in 7 mm plywood with a couple of the supplied twist drills. I would recommend this product

DO NOT BUY! The picture tells you why but let me explain. I sometimes need to shave 1/8 of the sides of a guitar body. So stupid me, I went cheep. Not noticing the other bent bit complaints a few others had. Got then and they looked Ok. A few months later I chucked one up in my trusty Makita router and spun it around by hand. Still looked OK. Turned it on and it immediately started wobbling at least a 1/4. Then bent, hit the guitar body and went flying out of the router. Fortunate no luthiers (me) were hurt. Did damage the router chuck and the guitar. :( So while most folks get good ones, the manufactures quality control must miss a few out-of-balance ones. Making then to risky to buy.

I used these to route mdf using a template guide. On first use, the ball bearing literally fell apart and flew off, leave a huge gouge into my template and desired workpiece. With that said, the cutting edges are as good as most premium router bits. Paint is atrocious and flakes off. these are quite wide, so youll want to have your router set to its highest rpm (if its variable) as the bit will want to jump and skip if the router is spinning too slow.

I use these to drill the barrels on my 40k miniatures, works a treat.