Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

It works not too badly but the free spinning top actually grates a lot. The chuck is quite central It drills holes - slowly but thats what I wanted I wish I had bought a better one

There have worked great

Cheap product, didn’t last more than 5 minutes each. Save your $ buy Freud.

These are horrible. quality, if you are roughing and edge maybe....bought them for the depth. the quality is absolute junk. do not buy

Good variety of sizes. Works well... Still requires quite a bit of presure to drill hard resin.

Good value

I had the items for 2 days before they both bent over in half on the router table. They cut great for a minute. Would not purchase.

Como se ven en la imajen , buen material y precisos.

this is a cheapo. so go slow and chew less meat. best to run a variable speed controller and run it at medium speed. if you fail to listen to this then u get what you get. dont be stew pedd cheerz p.s. i would buy again if i blow this one up

My guitar top was over the size of the back and so I flipped it over and put this bit in my router table adn slowly worked my way around the guitar body. It did a beautiful job at replicating the wall of the back of the body on the faces edge to match. The blade isnt blunt or chipped after that job and it hardly smoked or heated going at a reasonable speed. because of the cheaper quality make sure you go with the grain or there WILL be tear out of the finer more delicate edges. tape up and do it right the first time. Thumbs up. PS. keep in mind a half inch shaft will not fit a domestic router bit hole. It has to be a quarter inch. Quicly arrived and well packed with their own little hard plastic cases, really stoked. Thank you.