Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q

BIT WORKED OUT PERFECTLY

Made a nice clean cut even through cedar.

Using cutter for rail and stile dado cuts for raised panel doors

Good quality bit. Highly recommend.

I thought I was getting a good deal on this bit, review seemed fine. I used this bit once, for a total of 10 minutes. First the paint coating melted, then the metal holding the carbide blades began to warp. Thank god I was wearing safety glasses, because 10 seconds after it started warping, one of the carbide blades flew off and hit my glasses. Never buying this brand again. Will update with a picture when I get back home.

worked fine as a tool. But people that say its for t-molding are nuts ...way too thick had to glue it all in ..NOT FOR T-MOLDING. TOO BOKU.

This bit couldn’t cut 4’ of particle board melamine from Home Depot…

Unfortunately, this cutter has a poor design and burns before it cuts, even at shallow passes. This one warped after the first use. Get the BOSCH 85526M 1/16 In. Carbide Tipped 3-Wing Slotting Cutter Bit instead.

Used for 3 cuts totaling about 4ft in plywood before it flung one of the cutting tips off, overheated, then warped severely.

This was to hard to use. Would not buy it again.