2-in-One Drip Irrigation Tubing Hole Punch & Fitting Insertion Tool - for Easier 1/4 Inch Fitting & Emitter Insertion

This tool makes puncturing the main irrigation tubing easier but I did have a little trouble using it to push the fitting into the tubing.

Comfortable to hold, and is very sharp. Easy to punch holes.

It was very hard for me to use even when I let the hose warm in the sun. Not for older folks that are weaker.

Works well. Don’t push too hard or you might go through both walls

The first time I used it. It went all the way thru the tubing and put a small hole on the opposite side.. I went back to the old one I had after that..

I just used this tool for the first time a few minutes ago to make a hole in a main line tube (1/2 Toro Blue Stripe) and insert a small tube with a drip head. 1. The hole puncher worked very well. It so easily punched a hole that I advise to be careful you dont punch out the other side. A few careful back and forth movements with a bit of pressure, and you have your hole. Also, the tip is sharp. Dont poke a hole in your finger and save the protective cap the tool comes with. 2. The other end made it very easy to insert the drip line into the hole. I know some people said they had problems with this, but I just threaded the line in like it showed in the video, put a finger or thumb over the open edge of the channel the line goes in, and inserted the line into the hole at very slightly off 90 degrees with a bit of pressure and a few back and forth movements. The tool seems well made. I highly recommend this product for maintaining your drip system.

Not much use untill you drill a 7/32 hole in one of the slots . Then you can use it to hold 1/4 barb fittings while installing them on tubing.

For those of us older gardeners with arthritic hands, this helps to install 1/4” hose with barbed fittings into 1/2” drip hose.

I love this tool! Soooo much better than the one came with the irrigation kit. Easy to use, punctures easily through the 1/2 pipe.

Not expensive and easy to use when adding emitter tubing to my my drip line. Thumbs up!