4 Pack Knotted Wire Wheel Brush for Angle Grinders, WENORA Wire Brush for 4 1/2 Angle Grinder with 5/8 Inch Threaded Arbor, with 5/8 Inch Arbor for Heavy Cleaning Rust, for Grinder

It should work well!

Used these wheels to sand down and clean a stock trailer for pain prep. They definitely held up and there’s lots of life left in them. Absolutely with the money.

These wire wheels are pretty hard to mess up. After just a few seconds in my 4 1/2 in it took the rust off an old piece of tube steel I had laying around, the old grease/dirt/rust buildup off an old 3/4 ton shock, and the paint off a 55 gal drum lid. I say that, however to be honest Im surprised I dont have any wires sticking out of me after looking at the wheel after the fact. A number of wires seem to of come loose and could be removed with minimal issue or force. They get the job done but I question the longevity.

The way these are made allows you to use them horizontal or vertical and because they use a heavier wire than on the wire wheels I have used. Cup wheels flair out, these maintain shape and regular wire wheels dont like side loading, these dont seem to mind and work well doing it. So far I havent seen any shedding of wire from the bristles but that dont mean it wont happen. Wear your eye protection and gloves.

I would suggest passing on these. The wire comes un-twisted and flys out running no where near the max rating rpm rating stamped on the cup.

This fit my angle grinder perfectly. The threads engaged well and the wheel fit nicely within the guard. I used it to clean up an old cast steel anvil. The wheel cleaned off the old rust , grime, and paint and left a polished finish with very little effort. The wire did not come loose or fall apart like some cheap wheels. At less than $5.00 each these are a great deal. Highly recommended.

These screw onto my Dewalt angle grinder perfectly and do a great job at removing rust and other materials from surfaces that I need to be cleaned up. The braided wires last longer and are stiffer than the wheels that do not have the braided wires. I will never go back to non-braided wire wheels again as these last longer and remove more surface material quicker. I also like to use these wheels on my welds to kind of clean up the spatter and some of the burn marks.

It should work well!

Used these wheels to sand down and clean a stock trailer for pain prep. They definitely held up and there’s lots of life left in them. Absolutely with the money.

great for removing rust off steel pipes. they work great