

5-Inch Hook and Loop Backing Pad Replacement Sander Pad for Ryobi RS290, RS280, P411, Milwaukee 6021-21 & 6034-21, Craftsman 315.112170,315.116940
-
Hotrod_TX
> 3 dayProduct appears to be of OEM quality. I am using on an older (blue) Ryobi sander. The RYOBI pad I replaced was for the sticky backed sanding pads. When I removed that backing pad, I noticed there were four dimples on the back, which are used to help center and locate the pad. The new pad did not have these. Using the old one as a template, I carefully drilled four partial holes in the dimple locations on the new pad and it was good to go. 5 minutes work to make an inexpensive accessory work like factory. Very satisfied and would buy again.
-
User
> 3 dayI followed the directions but this pad came off during the very next project
-
Marcelo DElia
> 3 dayI used it to replace my worn out Ryobi backing pad. It has Velcro, just like original, so the sanding pads attach to it. The hole pattern is exactly the same as the Ryobi. It fits and works just like original.
-
JULE KOCH
> 3 daynothing
-
Dave
Greater than one weekExactly what I needed and fit perfect.
-
Glenn Peck
> 3 dayPrompt delivery, easy change out and fit perfectly.
-
Paul Peters
> 3 dayFit my sander with no problems at all. Thanks folks
-
Brent A.
> 3 dayWorks like the orginal
-
DAE
Greater than one weekWorked on my Ryobi sander
-
Billy
Greater than one weekWould by again