

5-Inch Hook and Loop Backing Pad Replacement Sander Pad for Ryobi RS290, RS280, P411, Milwaukee 6021-21 & 6034-21, Craftsman 315.112170,315.116940
-
Ursan
Greater than one weekThe quality of this Velcro is not consistent with OEM. It is not really latching on to name brand velcro backed discs and is just tearing them up from the inside. Switched back to Ryobi OEM replacement part and that solve the problem
-
Tdockery
Greater than one weekGreat product
-
Matt
> 3 dayUnfortunately this product would not hold the sandpaper to the sander at all, they would fly off within seconds of turning on the device. When comparing to my old pad, the hooks or significantly smaller and smoother providing significantly less hold.
-
Kyle perry
> 3 dayPut my Milwaukee 5 sander adheres great.
-
Christopher
> 3 dayIf anyone else is wondering, these DO fit Ryobi p410 orbital sanders. Based on other comments here I wasnt sure but I took a chance and it worked out. Please note that if your original pad is starting to give out, the stabilizer directly above/behind it may be deteriorated as well. Its an important part.
-
Patrick
> 3 dayThrew this on in a matter of minutes, flat face, working perfectly for 6+ months so far
-
Linda F.
> 3 dayThis hook and loop pad fit my sander great. The hardest part was getting the screws replace so that the sander worked properly. After I learned how to adjust the level of the screws, everything was great. The Hook and Loop held onto the sanding pads great after a few tries. It had to be broken in by using 100 grit or higher. The 60 and 80 grit sanding pads were too rough to start. Later, the hook and look pad took ahold of the rougher grits. Patience was my moto.
-
Michael Bernard
> 3 daywas surprised to find these so easily. great replace ment
-
BF
> 3 dayEasy install and got my palm sander up and running again.
-
Larry
Greater than one weekPerfect fit.