

5881ENH - Ademco Wireless Receiver
-
Ronnie D
> 24 hourWorks and fits well. Exactly as described.
-
Dale in Tennessee
> 24 hourI got this to replace an 8 channel Ademco Tx/Rx of the same type. This was a simple install, basically a plug and play with no issues whatsoever. Of course, the channels had to be adjusted, but once that was done, this works like a charm. I have no facts, but this SEEMS to have a bit longer range as I can use my key fob further from the house than I could with the older unit. Again, I did not measure it, it just seems to have greater spread of the signal.
-
M. Stevenson
> 24 hourGood price
-
AW
> 24 hourwork perfect with my existing Honeywell alarm sensors.
-
Andrew
> 24 hourWorks great I have you can have up to the max wireless zones with it its very easy to install and you dont need to program anything
-
SSS
> 24 hourGreat Item, I did work with my system. I wish it did as its what I am looking for.
-
Paul Michelsen
> 24 hourPretty easy to install using the provided instructions. I added it to my Vista 20p system so that I could add a few wireless four-button remotes. In my installation I removed the board from its plastic housing and mounted it directly in the Vista 20p box. After hooking up the wires on the appropriate terminals I was cooking with gas. No additional setup required.
-
B T
> 24 hourPrevious wireless receiver was 8 zones so needed upgrade to this unit to accommodate more wireless contacts.
-
DMBFL
> 24 hourWorks perfectly
-
WJ
> 24 hourI upgraded from the 5881ENL because I needed a 9th zone for adding another CO detector. I was hoping the upgrade would not require me to re-program my existing 8 wireless zones, and in fact I found that the former programming carried over completely and the only programming needed was to add the new zone. So that means all configuration data for the wireless zones is saved in memory on the Vista-20P and not in the 5881. As a result, the swap out took about 15 minutes.