

















Black Touch Screen Digitizer Repair Kit for iPad 9.7 2018 iPad 6 6th Gen A1893 A1954 Front Glass Replacement (Without Home Button,not Include LCD) +Pre-Installed Adhesive + Tools
-
Cristana
> 3 dayIt works good, but had issues with the screen adhesive on the cable side. Seemed it would have been fine, but the cables were a bit bulky when trying to fold the screen down
-
Charlena R
> 3 dayLove it thanks!
-
shopping addict
> 3 dayThe tutorial on line is worthless, there music playing during the entire video, and no one is speaking to or describing the installation steps. Also, there was no protective film on the inside of the screen,
-
Peña
> 3 dayWas fixing the screen for a friend on two of her iPads and these fit perfectly on hers to be able to replace the broken screens! Definitely recommend this product!
-
Jake Miller
> 3 dayAlmost! I repaired my iPad with this and all seemed well. Until a strip of the screen was unresponsive to touch. I tested it by drawing in the notes app and low and behold, not only was there a 1/2 strip in the middle of the screen from left to right, but there were dead spots in the corners too. Seems as if I got a malfunctioning Product. I doubt its anything on my end.
-
Matt C.
11-06-2025On the bottom right side where the touchscreen cables attach to the mainboard and the home button attaches as well, the pressure put on the back of the screen was enough to keep separating the digitizer from the body of the iPad. I tried 2 or 3 times to gently heat the digitizer and then use plastic spring clamps to hold the digitizer down while it cooled. Not very satisfied with the adhesion.
-
DaveO
> 3 dayMost would be better off taking this in for repair. I think its hit or miss if the screen is going to work or not. The bottom of my screen is unresponsive after install. Edit: I just upgraded review from one to three stars. Amazon sent me a new screen and it works fine...but during installation I peeled off the screen protector as I was about to install the screen and noticed that a section of the double back tape was stuck to the cabling (it came that way from the manufacturer). Those cables are small and I couldnt get the tape off without damaging those cables so I installed it as is. That section of the screen is not sticking to the case now. Overall, its OK and I can always fix that issue if the screen starts to come off (I now have experience and I had also purchased B-7000 glue for the installation which I highly recommend) But as I said before, quality is a hit or miss. Update: After several months the middle of the screen is now unresponsive. I recommend paying for a high-quality screen.
-
SRT
> 3 dayGood quality. The adhesive is a little weak, but the contact areas are well insulated so no ghost touches. Also no observable grid lines. I have replaced a lot of these over the years and this is a quality part. Just be sure to clean off any old adhesive to maximize the adhesives effectiveness.
-
NMercado
> 3 dayDigitizer was packaged very securely. Good quality of digitizer.
-
Mehnaz Zafar
> 3 dayI like the screen. The quality is good