Chipquik Tack Flux no clean in a 10cc syringe w/plunger & tip - SMD291

Rosin stay close to your soldering point. Pricey

Love the dispenser and the flex works very well. Cleans up with alcohol nicely.

This stuff is great, will be buying again.

Works great small spout so i can deliver just the right amount of flux.

Good quality, works great

my go to flux.

Used this product on a 100 pin ARM chip. The Flux was a bit too wet. It did not seem to work very good for me while trying to solder the fine pitched pins onto the pads. I had too much bridging. Also, the product made quit the mess. It took a few cleanings to get the flux off of the board. I discarded the product and reverted back to using a Kester Flux pin. Less bridging, and less of a mess to clean.

Nice. Works as it should. thanks

This stuff is wonderful! ^ Review over. Seriously though this stuff is great to solder with. My only gripe is that when you take the needle like tip off they dont give you anything to put it in.... which can prove to get messy over time. Either have a small plastic cap that covers the needle and it would make a world of difference for storage. Same goes with the plunger itself. They should have a little clip that you can snap the two together so everything stays together. -Nigel

I dont agree with the no clean part as it leaves a sticky residue, which I eventually clean with isopropyl alcohol. But it does what its suppose to, so Im satisfied.