













CHPOWER CR10 Supporting Rod Set for Creality CR-10/CR-10S/ CR-10 V2/V3, Upgraded 3D Printer Accessories
-
Travis U
> 24 hourGreat edition to the cr-10, with the Z gantry being so tall its nice to be able to stiffen the frame up. Easy to install and very well packed. Definitely recommend using a machinist square during set up to maintain proper angles.
-
Vince
> 24 hourDoes the job in stiffening the z axis frame although the rods are split in 2 pieces so they are not 100% straight.
-
Christopher S.
> 24 hourNice, solid support rods for my MP10. Easy to instal and work great.
-
steven a unzeitig
> 24 hourproduct is well made. fast shipping.
-
Derpasaurus Rex
> 24 hourDefinitely does as advertised, the support rods do a great job of stabilizing the gantry. The really nasty layer shift problem I had on tall prints went away after installing these. The install itself does take a bit of work and knowhow. You do have to tap out the center channel of the front frame member to attach the support rods, (the tap is included with the kit), and once that is done everything else is just simply bolting the rods on and tensioning them. Price was decent and other than needing a little extra work to install Ive been very satisfied with these.
-
daniel keach
> 24 hourDirections clear, wish was two single bars instead of four that assemble but whatever. Printer solid now
-
AndrewF
> 24 hourThe picture must be an older version. The one I received, had 4 brackets. Instead of having to tap for the lower mount, mine came with two straight brackets that bolted with t-nuts into the bottom channel. Picture attached. The only issue I had installing is one of the threads in one of the supports was not properly done. Needed to chase it with a tap to clean the threads to insert one eye bolt.
-
Anthony Maniscalco
> 24 hourThis is a great item to add to your 3D printer. It does greatly stabilize the Z Axis and makes the whole printer more rigid. I fit this on the ADIMLab Gantry I3 printer, but did not use the included mounts (or tapped the bottom), I printed my own mounts for top and bottom and it fit perfectly, and works great!
-
J&C&e
> 24 hourDoes just what it should - Make the Z not wobble. Easy to install.
-
Steven D Houtzager
> 24 hourLooks great, best I have seen. It just needed instructions. I tapped the first hole without issue but the second hole I did not think about the bolt behind the hole and i broke the tap. So I had to make a bracket. Probably should avoid the tapping and have 4 brackets.