Comgrow 3D Printer Enclosure, Fireproof and Dustproof Tent for Ender 3 S1 Plus/Ender 3 Max/Ender 3 Max Neo/Ender 5 S1/Ender 5 Plus/CR-10Smart Pro/SV04 Cover Room Storage 750x700x900mm

Does the job perfectly. does need a light as is is dark inside.

This thing is good quality. I have had no problems yet with it. It went together really ready. It seems really sturdy. My ender 3 S1 pro fits perfect with a little extra room. I put a sensor to give me temperatures and relative humidity, and when I’m doing larger prints and the tent stays shut it has reached temps upwards of 98 degrees Fahrenheit and around 20 for the humidity. The material it’s made out of as well seems pretty sturdy too.

Tent met all expectations and will buy again. Easy to assemble. Plenty of options to vent or run cables

Saved all my crappy prints. Shouldve bought it sooner!

Little surprised it has vent cutouts on all the walls. Keeps everything nice and toasty while Im printing ABS. Im made some simple modifications to it, like zip typing a couple of led panels to the top, as well as a webcam.

This houses my Anycubic Mono X resin printer and it is the perfect size. I have a small heating pad under the printer the tent keeps the heat in rather well. Also helps a lot with the smell that comes with resins.

Honestly I just looked at the photo and dimensions and clicked buy because I needed something to keep the cats off my printer—didnt realize this was an insulated vinyl casing around a metal frame. If you dont look closely the photo looks like its a solid container. Anyway, it does the trick. I was lazy and didnt want to move my 3D printer so I cut a square hole out of the bottom and lowered it over the printer. My cats hate the sticky insulated material so they havent even gone near it, and the zipper access is convenient. 8/10, decent budget solution.

I bought this as a preventative measure for my Anycubic Kobra, since I have a heated bed and dont want to loose my house in case of a runaway. This definitely holds the heat in which helps with energy consumption to keep the bed and nozzle up to temp. I havent tried abs in it yet, but that is on my list. The cover is a heavy rubber on the outside with silver lining inside, the door zippers up nicely. The only downfall I could see to improve on is a lighting kit for it. Its tough to see whats going on inside. I wish they offered a larger one for my Kobra Max.

Works well on my sidewinder being of a generous size and does a very good job at containg ABS fumes inside the enclosure instead of letting them into my room. It is pretty annoying to assemble by yourself due to the canvas tent being very tight on the metal rails, but if you get some gloves on you can slide the zippers over the corners and pull them in. Packs up very small as well if you ever need to transport it, but dont expect to be removing it after a print..

Was extremely pleased with the LARGE COVER. Even though my Anet A8 Plus is not listed as being a fit, I can assure it is a perfect fit. The power cord hole, power supply access, and CPU flap are in compatible locations. The single sheet instructions with six diagrams leave a lot to be desired, but got it assembled. I would say it is well worth the cost.