













Comgrow 3D Printer Enclosure, Fireproof and Dustproof Tent for Ender 3 S1 Plus/Ender 3 Max/Ender 3 Max Neo/Ender 5 S1/Ender 5 Plus/CR-10Smart Pro/SV04 Cover Room Storage 750x700x900mm
-
Tina
> 3 daySturdy, basic and convenient.
-
Fishing Relentless
> 3 dayVery nice enclosure, more room than I thought, my entire printer including front camera mount and top and chose the smaller of the two. The temperature stays perfect, not too hot, just warm, keeps the cold drafts in the house from disrupting your prints. Regardless if you need an enclosure or not, having one is always a plus and your prints will turn out better The instructions are lacking, but not difficult to assemble.
-
SGT Smitty
Greater than one weekKeeps heat on very well but plan on adding a light to your printer for visibility!
-
aaron
> 3 dayMade very well and put together in 5 minutes
-
Felix
14-06-2025Good investment for printing ABS. My raspberry pi reports around 45C with bed at 90C, 55C with some Acoustic Panels.
-
TEBASS
> 3 dayVery good protection, good insulation and easy to assemble, great product for my Ender 5 Plus, recommend!!! Thanks...
-
S. Phillips
> 3 dayPerfect size for CR10V2, but you may need to get creative with the spool. The purple spool is my currently location and doesnt interfere with any of the axis or the filament guide/motor. The controller box does not fit inside. I have found that if I am messing with my printer too much, and touching the inside with bare skin, I will get fiberglass splinters. If you find your skin is itchy, look under a bright light to find them, and try using clear tape if you are having trouble getting them out. Heres my spool and wired light, but led strip lights work well also. https://www.amazon.com/gp/product/B09DL335M2/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 https://www.amazon.com/gp/product/B0972HFBRL/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
-
John
Greater than one weekWas easy to put together, fabric is thick. After further testing, this enclosure has about 2 inches clearance from the top of a regular 1kg spool for the CR10s Pro. This fits and works great!
-
3d prints this week
> 3 dayThis enclosure seems massive at first but it gives you the space you need to work on your printer without having to remove it. It works as intended and even helps isolate the noise. A great addition for the ender 5 plus.
-
Sean P Mc Grath
> 3 dayWould recommend. Cost effective alternative with the same level of performance. Helps with the printing.